The do-it-yourself product

Vulcan is especially designed so that the installation does not need to be done by a specialized plumber. You can easily install Vulcan in approx. 10-15 minutes. The installation does not require any tools and there is no need to cut the pipe.

Notes on the installation

1 For optimal water treatment Vulcan is best installed near the water meter or at the main water supply.

2 The impulse band windings can be placed on the left side, on the right side or underneath the electronic device. Leave a safe distance of at least 1 cm (min. ~1/2”) from each other.

3 Vulcan can be installed vertically, horizontally or at any other angle. If there is no space available on the pipe the device can also be wall-mounted.

4 In case of limited space the windings can be placed partly on the main pipe and partly on the distributor pipe.

All these different installations are possible because the treatment impulses extend over several meters to either side of the pipes. installation-water-softener-alternative-examples instructions private line A instructions private line B

Installation instructions for the Private Line

1 Put the two band holders through the fixing holes at the bottom of the electronic device. Now place the device onto the pipe. Use the band holders to latch the device to the pipe.

2 Connect one of the impulse bands to the device and use another band holder to latch it to the pipe.

3 Wind the impulse bands around the pipe producing a coil. Make sure you wind the band tightly to the pipe and place the windings close to each other.

4 Latch the end of the band to the pipe using another band holder. Now repeat the procedure with the second impulse band.

5 Connect the power supply unit with an electrical outlet and plug the connector into the upper right in-jack of the device.

6 The red pilot lights will illuminate as soon as the device starts to operate. Vulcan works from now on maintenance free.

In comparison to softeners Vulcan don't need any maintenance.

Installation instructions for Commercial and Industrial Line

1 Put the two band holders through the fixing holes at the bottom of the electronic device. Now place the device onto the pipe. Use the band holders to latch the device to the pipe.

2 Plug one of the impulse bands into the bottom impulse band in-jack and latch it to the pipe using another band holder.

3 Wind the impulse bands around the pipe producing a coil. Make sure you wind the band tightly to the pipe and place the windings close to each other.

4 Latch the end of the band to the pipe using another band holder. Now plug another impulse band into the in-jack on the opposite side and repeat the procedure.

5 Plug another impulse band into the next impulse band in-jack and, according to the device type, repeat steps 2 - 4 until all impulse bands are in use. All impulse bands must be wound tightly around the pipe and fastened with band holders.

6 Connect the power supply unit with an electrical outlet and plug the connector into the upper right in-jack of the device.

7 Now adjust your Vulcan on the side sensors according to your pipe diameter to optimally treat your water.

Vulcan don't need any maintenance and is the eco-friendly alternative to water softeners.

General information

1 Protect the power supply unit against exposure to direct water.

2 Use the included switching power supply unit only.

3 Do not cut the impulse bands nor the 24 V power cord of the power supply unit.

4 Do not remove the end caps or the impulse band insulation.

5 The operating temperature of Vulcan ranges from –20° C to +50°C (-4°F to 122°F).

6 Clean the device with water only.

7 Temperature peaks on heating surfaces should not exceed 95°C (203°F).

Installation Manual